Connecting To A Power Source - Samsung ES68 User Manual

Connecting to a Power Source

You should use the rechargeable battery BP70A supplied with the
camera. Be sure to charge the battery before using the camera.
Ê
Model BP70A
Type Lithium lon
Capacity 740mAh (Minimum: 700 mAh)
Voltage 3.7V
Charging time Approximately 150 Minutes
Ê Number of images and battery life: Using the BP70A
Battery life /
Number of images
Approx. 120 MIN /
Still image
Approx. 240 shots
Movie Approx. 110 MIN
Ä
and shooting conditions and may vary depending on the user's
methods.
012
Conditions
Using the fully charged battery, Default
settings, Program mode, Shot to shot
interval: 30Sec.
Changing the zoom position between
the Wide and the Tele after every shot.
Using the camera for 5 minutes and
then powering it off for 1 minute.
Using the fully charged battery
640x480 image size
30fps frame rate
Important information about battery usage.
å When camera is not in use, turn off the power.
å Please remove the battery if the camera will not be used
for long periods. Batteries can lose power over time and are
prone to leaking if kept inside the camera.
å Low temperatures (below 0°C) can affect the performance of
the battery and you may experience reduced battery life.
å Batteries will usually recover at normal temperatures.
å During extended use of the camera, the camera body may
become warm. This is perfectly normal.
Ê Connecting the AC adapter with the USB cable can be used as an
AC cable, and you can charge the rechargeable battery with the
AC cable.
- Using an AC cable
: Connect the AC adapter to the USB
cable. It can be used as a power
cable.
- Using a USB cable
: Remove the AC adapter.
You can download stored images
to your PC (p.89) or supply the
power to your camera through the
USB cable.