Metering; Drive Mode; Drive - Samsung HZ50W User Manual

Shooting ( )

Metering

If you cannot obtain suitable exposure conditions, you can change
the metering method to take brighter pictures.
[Multi] ( ) : Exposure will be calculated
based on an average of
the available light in the
image area. However, the
calculation will be biased
towards the center of the
image area. This is suitable
for general use.
[Spot] ( ) : Only the rectangular area in the center of the LCD monitor
will be metered for light. This is suitable when the subject
in the center is exposed correctly, regardless of the back
lighting.
[Center-wei ghted] ( )
: Exposure will be calculated based on an average of the
available light in the image area. However, the calculation
will be biased towards the center of the image area. This
is suitable for taking a picture of small object like a fl ower
or insects.
If the subject is not the center of the focus area, do not use the
spot metering as this may result in an exposure error. In this
circumstance, it is better to use exposure compensation.

Drive mode

You can select continuous shot, and AEB (Auto Exposure Bracketing).
[Single] (
[Continuous] (

Metering

[High-speed] (
Back Move
[Motion Capture] (
[AEB] (
) : Take one picture only.
) : Images will be taken
continuously until the
shutter button is re-
leased.
) : Continuous shooting is
available while pressing
and holding the Shutter button (About 6.5 frames
per second). The shooting speed may get slower
depending on the shooting environment or the
number of shots. (Up to 3M Size)
) : This takes 10 shots per second, when the shutter
is pressed and held down. After completing the
continuous shooting, images are saved and the
images play back on the Rear LCD. The maximum
number of shots is 30 and the image size is fi xed
as 1024X768.
) : Take three consecutive photos with varying
exposure values. Use this mode if it is hard to
decide exposure of the object.

Drive

Back Move
055