Advertisement
LC-40/46/52/60LE835U/830U/832U/LC-60LE831U
CHAPTER 5.
LC-40LE830U
ADJUSTMENT
[1] ADJUSTMENT PROCEDURE
The adjustment values are set to the optimum conditions at the factory before shipping. If a value should become improper or an adjustment is
required due to part replacement, make an adjustment according to the following procedure.
1. After replacement of any PWB unit and/or IC for repair, please note the following.
• When replacing the following units, make sure to prepare the new units loaded with updated software.
MAIN Unit:
DKEYMF733FM16:
DKEYMF733FM14:
DKEYMF733FM13:
DKEYMF733FM12:
DKEYMF733FM04:
DKEYMF733FM03:
DKEYMF733FM02:
DKEYMF733FM01:
DKEYMF733FM18:
DKEYMF733FM10:
DKEYMF733FM08:
DKEYMF733FM07:
DKEYMF733FM06:
• When replacing the LCD control PWB, perform the VCOM adjustment.
2. Upgrading of each microprocessor software
CAUTION: Never "POWER OFF" the unit when software upgrade is ongoing.
Otherwise the system may be damaged beyond recovery.
2.1. Software version upgrade
The model employs the following software.
•
Main software LC-40/46/52/60LE835U (please use a software version after BSMK_LE835_xxx.USB).
•
Main software LC-40/46/52/60LE830U/832U/LC-60LE831U (please use a software version after BSMK_LE830_xxx.USB).
•
Monitor microprocessor software (please use a software version after BSMK_LE835_xxx.USB (for LE835U) or BSMK_LE830_xxx.USB (for
LE830U/LE831U/LE832U) and BSMKMxxx.SMB.)
The main software, monitor microprocessor software can be upgraded by using a general-purpose USB Memory.
The followings are the procedures for upgrading, explained separately for the main software, monitor microprocessor software.
2.2. Main software version upgrade
2.2.1 Get ready before you start
•
USB Memory of 128MB or higher capacity.
•
PC running on Windows 98/98SE/ME/2000/XP operating system.
•
USB Memory reader/writer or PC with a USB port.
•
The file system of a USB memory is FAT. (FAT32 supports)
•
Use the USB memory without other functions. (lock and memory reader...etc)
2.2.2 Preparations
To upgrade the main software, it is necessary to get ready the USB Memory for version upgrade before you start.
Follow the steps below and create the USB Memory for version upgrade.
1. Copy the file BSMK_LE835_xxx.USB (for LE835U) or BSMK_LE830_xxx.USB (for LE830U/LE831U/LE832U) for version upgrade to the root
directory (folder) of the USB Memory.
NOTE: In the USB Memory drive, do not store other folders or unrelated files, or more than one file for version upgrade.
Now the USB Memory for version upgrade is ready.
LC-40LE835U
LC-46LE835U
LC-52LE835U
LC-60LE835U
LC-40LE830U
LC-46LE830U
LC-52LE830U
LC-60LE830U
LC-60LE831U
LC-40LE832U
LC-46LE832U
LC-52LE832U
LC-60LE832U
Service Manual
5 – 1
Hide quick links:
Advertisement
Troubleshooting
