Advertisement
Installation
1 Place the alarm in the desired location,
preferably near the front or back door.
2 Remove the back cover and fix it to the wall
using the screws and
rawplugs supplied, (as
shown in image D).
3 The alarm body can then
be snapped into
place on to the back cover
and secured using the
screw at the base.
• Note: This alarm can
also be used free standing.
Operation
Leaving the protected area
Press keypad number 4 and a confirmation tone
will indicate that the alarm is armed. You have
30 seconds in which to vacate the area. After
this time, if motion is detected then the alarm
will sound.
Entering the protected area
Type your 4 digit security code within 10 seconds.
This will disarm the alarm.
Care and maintenance
To clean the case, simply use a soft slightly damp
cloth with water and wipe dry immediately.
Caution: Never use chemicals to clean the case,
as they may cause damage to the plastic and
cause the alarm not to function.
Troubleshooting
The unit does not sound when the batteries
are installed
Ensure that the batteries are connected correctly
following the polarity (as shown in image C).
D
The alarm does not arm
Ensure that the back plate of the alarm unit is
secure to hold the batteries in place and that the
red light illuminates when the keypad buttons are
pressed.
The red light on the base of the alarm is on
This is the 'Battery Low Indicator'. The batteries
need replacing.
Battery precautions
When using this product follow these precautions at all
times.
• Use only the appropriate size batteries
• Be sure to follow the correct polarity when installing the
batteries as indicated in the battery compartment.
Incorrect polarity may cause damage to
the alarm.
• Do not mix different types of battery such as Alkaline and
Carbon-zinc or old batteries with new.
• If the alarm is not used for long periods of time, remove
the batteries to prevent damage or injury from possible
battery leakage.
• Do not recharge batteries not intended to be recharged
as they can overheat and rupture. (Always follow the
manufacturer's directions).
Note: Waste electrical products and batteries should not be disposed
of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Information and illustrations are subject to change. Yale reserves the right to
alter the specification and product design at any time without notice.
Advertisement
