Ispezione, Trasporto; Ispezione; Stoccaggio; Sollevamento E Trasporto - TATA Motors TSR Series Installation, Use And Manteinance Manual

Table of Contents

Advertisement

4.

ISPEZIONE, TRASPORTO

4.1

ISPEZIONE

All'atto del ricevimento dell'unità, verifi carne l'integrità.
Poiché la macchina è stata accuratamente controllata
prima di lasciare la fabbrica, eventuali danni sono da
imputare al trasportatore. Si raccomanda perciò di an-
no tar li sul Foglio di Consegna prima di controfi rmarlo.
Avvisare tempestivamente la società o l'Agen te sul l'en ti tà
del danno riportato dall'unità.
Il Cliente deve sempre compilare un rapporto scritto che
riguarda ogni eventuale danno subito dalla macchina.
4.2

STOCCAGGIO

La temperatura dell'ambiente in cui vengono im ma gaz z-
i na te le unità deve essere compresa tra -20 e +50°C.
4.3

SOLLEVAMENTO E TRASPORTO

Durante lo scarico ed il posizionamento dell'unità, pre-
sta re molta attenzione alle manovre che non devono in
alcun modo essere brusche e/o violente. Non utilizzare
come punti di sollevamento le tubature o altri com po -
nen ti della macchina.
Attenzione!
In tutte le operazioni di sollevamento as si cu -
rar si di aver ancorato saldamente l'unità per
evitare ribaltamenti o cadute ac ci den ta li.
4.4

DISIMBALLO

L'imballo va tolto solo quando l'unità è giunta sul posto
di installazione e non dovrà più essere movimentata.
Rimuovere con cura l'imballo della macchina, evitando
di danneggiare la stessa.
Poiché i materiali che costituiscono l'imballo sono di
natura diversa (legno, nylon, polistirolo, cartone, ecc.), si
consiglia di conservarli separatamente e di con se gnar li
alle ditte specializzate nello smaltimento e nel riciclaggio
degli stessi allo scopo di salvaguardare l'am bien te.
14
TSR 18 ÷ 131
4.
INSPECTION AND TRANSPORT
4.1
INSPECTION
Check the condition of the unit on receipt. As the unit
was carefully checked before leaving the factory, any
claims for damages should be addressed to the for-
warder. Any damage should therefore be indicated on
the Delivery Note before signing it.
Please inform the company or the Agent of the nature
of the damage to the unit immediately.
The Customer must always write a report describing
any damage caused to the unit.
4.2
STORAGE
The temperature in the area where the units are stored
must range between -20 and +50°C.
4.3
LIFTING AND TRANSPORT
When unloading and positioning the unit, take great care
not to make sudden and/or violent manoeuvres. Do not
lift the unit by its piping or any other components.
The unit should only be moved as shown in the plate
attached to it.
Attention!
Make sure the unit is securely anchored
before lifting it in order to prevent it from
accidentally overturning or falling.
4.4
UNPACKING
Only unpack the unit when it has reached the installation
site and no longer needs to be moved.
Remove the packing material with care, making sure
not to damage the unit.
Given that various kinds of packing materials are used
(wood, nylon, polystyrene, cardboard, etc.), they should
be separated and delivered to specialised disposal and
recycling companies for environmental reasons.

Advertisement

Table of Contents
loading

Table of Contents