Table of Contents
Advertisement
Continuity test
Do not enter a voltage above 10 V! Make sure that the power supply to the circuit is disconnected
and all capacitors are discharged.
1. Turn the rotary switch to
The continuity test is now active.
2. Plug the red test lead into the INPUT socket and the black test lead into the COM socket.
3. Connect the probes to the circuit or component under test.
4. If the resistance is <30 Ω an acoustic signal sounds continuously and the orange backlight lights up.
Note: When measuring resistance
on a circuit,the measured value can
be influenced by other circuits.
Open circuit voltage: approx. 2V
Overload protection: 250V
and press the "FUNC." key several times until
12
Red
Black
appears on the display.
Advertisement
Table of Contents
