Automatic Programs - Hotpoint MC 057 AX0 Operating Instructions Manual

it en
Setting of the cooking function: temperatures
from 37°C to 100°C.
1. Press the TEMPERATURE button: on the display
the corresponding icon is flashing.
2. Set the temperature by turning the knob
clockwise + and anti-clockwise - to increase or
decrease the selected value (Figure C).
Setting the timer function
1. Press the TIMER button: on the display the
corresponding icon flashes as well as the area
dedicated to minutes.
2. By pressing again the TIMER button you select
the area dedicated to seconds.
3. Set the time by turning the knob clockwise +
and anti-clockwise - to increase or decrease the
selected value (Figure C). The maximum time
which can be set corresponds to 99 minutes
(Figure D).
Start of processing
Please do not move the device when it's ON.
Activate the device by pressing the START / PAUSE
button; on the display you will see (Figure E):
• Set speed
• Set temperature: the "C°" symbol flashes until
the temperature is reached
• The elapsed time, unless a specific timer was set
• The residual time before the end of the
processing if the timer was set
Change settings
You can change speed, temperature or set time even
after starting the processing:
1. Press the buttons
temperature or timer: the corresponding icon
flashes.
2. Set the value by turning the knob
3. You can change the set value as long as the icon
keeps flashing.
Temporary stop of the processing
If necessary, please open/close the lid in order to
check the processing status; pause and proceed as
follows:
1. By pressing the START / PAUSE button: the
processing temporarily stops (temperature,
speed and time).
2. To restart immediately, press again the START/
PAUSE button. If this button is not pressed within
28
about engine speed,
20 minutes the device turns off.
If the lid is opened without pausing first the
device immediately blocks - for safety reasons -
the engine rotation; the cooking and timer functions
remain active in order to allow the continuation of the
process. To restart the processing just close the lid.
The POWER button and the STOP/CANCEL
button must be pressed for about 1 second
in order to be activated.
The POWER and the STOP/CANCEL button
cancel current settings.
Pulse function
Hold pressed the PULSE button for 2/3 seconds, then
release it; repeat this operation several times; on the
display the corresponding icon will light.
The PULSE function (pulse processing) cannot be
used on a previously set processing.
End of the processing
When the timer-set time is over (or after 30 minutes
from the start of the processing without timer) the
device will emit an acoustic signal and on the display
"END" will appear; the device will keep mixing for
2 more minutes in order to prevent the food from
sticking on the bottom of the container.
Press the STOP button when you prefer. Should this
button not be pressed within 3 minutes, the device
switches to "energy save" mode.

Automatic programs

1. Press the AUTOMATIC programs button: a
screen very similar to the one showed in Figure
F will appear.
2. Turn the knob in order to reach the selected
program.
3. After selecting the program you can select
the portions by pressing again the automatic
programs button;
quantities will vary accordingly.
If the container is removed during an automatic
cycle, the display shows the "E3" error
message. Replace the container on the unit and press
STOP/CANCEL to re-activate the screen and go on
with the processing.
At the end of the cycle the display shows the
"END" message.
times and ingredients