Fantom FM718 Instructions

HEPA Filter
Cleaning HEPA Dust Cup Filter
1. To remove the HEPA filter, unlock and remove the dust cup container
cover by turning the cover to the right until the arrow on the cover aligns
with the arrow on the handle and then lifting the cover off.
2. Remove the HEPA Rinseable "Tap Clean" filter from the dust cup. To
remove the HEPA filter from the dust cover, push the cover up with your
thumb.
3. Vigorously "TapClean" the HEPA dust cup filter on a hard surface until
no more dust is observed falling out. The HEPA filter may also be
washed by running it under the tap allowing the water to run on the dirty
side. We recommend washing it once a month or when suction appears
reduced. Always allow 24 hours for air drying before replacing into the
vacuum.
Please Note
:The HEPA dust cup filter should be replaced every 6 months
depending on usage.
Warning
: It is very important to ensure that the fine dust which adheres
to the filter media is completely removed. This fine dust
powder that is left on the filter will severely reduce the
suction performance of your vacuum. Clean HEPA filter every
time the dust cup is emptied.
Warning:
Always empty the dust cup and clean the HEPA dust cup
filter after each use and during prolonged usage. Never
over fill the dust cup - remove dirt and clean the HEPA
dust cup filter each time the dust cup is emptied during
prolonged usage or risk motor damage.
Fig. 1
NOTE: DO NOT OPERATE VACUUM WITHOUT FILTER IN PLACE.
Printed in China
Fig. 2
Rev. 03/04
HEPA Filter
Cleaning HEPA Dust Cup Filter
1. To remove the HEPA filter, unlock and remove the dust cup container
cover by turning the cover to the right until the arrow on the cover aligns
with the arrow on the handle and then lifting the cover off.
2. Remove the HEPA Rinseable "Tap Clean" filter from the dust cup. To
remove the HEPA filter from the dust cover, push the cover up with your
thumb.
3. Vigorously "TapClean" the HEPA dust cup filter on a hard surface until
no more dust is observed falling out. The HEPA filter may also be
washed by running it under the tap allowing the water to run on the dirty
side. We recommend washing it once a month or when suction appears
reduced. Always allow 24 hours for air drying before replacing into the
vacuum.
Please Note
:The HEPA dust cup filter should be replaced every 6 months
depending on usage.
Warning
: It is very important to ensure that the fine dust which adheres
to the filter media is completely removed. This fine dust
powder that is left on the filter will severely reduce the
suction performance of your vacuum. Clean HEPA filter every
time the dust cup is emptied.
Warning:
Always empty the dust cup and clean the HEPA dust cup
filter after each use and during prolonged usage. Never
over fill the dust cup - remove dirt and clean the HEPA
dust cup filter each time the dust cup is emptied during
prolonged usage or risk motor damage.
Fig. 1
NOTE: DO NOT OPERATE VACUUM WITHOUT FILTER IN PLACE.
Printed in China
Fig. 2
Rev. 03/04