Advertisement
Press here to release and pull to disconnect
9. Charging will take 14-16 hours for a fully discharged
battery. When the battery is charging the red LED is lit,
when the battery is charged the green LED is lit.
10. Disconnect the Charger from the mains.
11. Unplug the battery cable from the charger cable.
12. Allow battery to stand for 30 minutes before using it.
13. When ready for use, place the battery into the housing
and connect the housing cable.
Silicone
Grease
SEAL
Fig.11
Ensure sealing surface is clean and
seal is lubricated
Fig.12
EXPLORER
23
14. Make sure the seal and sealing surfaces are clean and fully
lubricated with the supplied grease EVERYTIME (you can
also buy this at your local hardware store) before
replacing the Nose Cone. See fig. 12.
15. Replace the Nose Cone and close the latches.
To replace a flat battery with a fully charged battery.
1. Follow the steps 1 to 3 on page 22, to open the
SEASCOOTER
.
™
2. Allow two minutes for gases to dissipate.
3. Unplug the battery at the socket by pressing the locking
feature shown in fig. 11.
4. Remove the flat battery.
5. When ready for use, install and connect battery in the
correct position, see fig. 13.
DO NOT STORE BATTERY IN SEASCOOTER.
SEAL
6. Follow steps 14 to 15 on page 22, to close the
SEASCOOTER
.
™
Buying batteries
Additional batteries can be purchased separately. Contact
your local customer service center/distributor to purchase
them.
EXPLORER
Fig.13
24
Hide quick links:
Advertisement
