Download Print this page

Yamaha Seascooter Scout User Manual page 13

Advertisement

15. Replace the Nose Cone and turn and lock the latches -
you will hear a click when they are locked. (see fig.9)
The SCOUT is now ready to be used.
Replacing a flat battery with a fully charged battery.
1. Follow the steps 1 to 5 above
2. Remove the flat battery.
3. Install the charged battery.
4. Follow steps 13 and 15.
Buying Rechargeable Batteries
It is a good idea to have a second battery so that when
one has run out you can swap it over with a charged
one.
Contact
your
center/distributor to purchase additional rechargeable
batteries.
21
A
B
Fig.9
local
customer
service
Charging the battery for SEAL /EXPLORER
Warning!
Replace the battery immediately if it is damaged.
For battery charging follow these instructions.
1. Always ensure that the Safety Lock in the Off position is
Off - see fig. 5b.
2. Always ensure that the SEASCOOTER
EXPLORER is out of the water, dry and placed in a dry
area.
3. Pull the latches down and remove the Nose Cone as
shown in fig. 10.
4. Allow two minutes for any gasses to dissipate.
5. Disconnect the battery cable from the housing cable
(if not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER
pressing the locking feature, as shown in fig. 11.
6. Remove battery and place on a level surface.
7. Connect the battery cable to the charger cable.
8. Plug charger into mains, and turn on the supply.
22
SEAL /
Fig.10
) by

Hide quick links:

Advertisement

loading

Subscribe to Our Youtube Channel

This manual is also suitable for:

Seascooter sealSeascooter explorer