Advertisement
Necessary repair and test equipment:
1. Philips-head screwdriver
4.1 Disassembly Procedures:
Remove the monitor stand base:
1. Place the monitor on a soft cloth or cushion.
S1
2. Press and hold the stand-release button.
3. Lift the stand up and away from the monitor.
Use a Philips-head screwdriver to remove four
S2
screws for unlocking mechanisms.
(No.1~4 screw size=M4x8; Torque=10~11kgfxcm)
Wedge your fingers between the rear cover and the
middle bezel on the corners of the top side of the
monitor to release the rear cover, then use one hand
S3
to press the middle bezel, the other hand to pull up
carefully the rear cover in order of arrow preference
for unlocking mechanisms of rear cover.
1
3
4. Disassembly and Assembly Procedures
2
3
4
1
2
4
Lift the rear cover up carefully. Disconnect the USB
FFC cable, joystick key cable and power key cable
from the connectors of the interface board, and then
S4
disconnect the back LED light bar cable from the
connector of the power board, and then remove the
rear cover.
Use a Philips-head screwdriver to remove one screw
for unlocking the USB board unit, then release the
S5
USB board unit and put it aside.
(No.1 screw size=M3x6, Torque=4
1
Use a Philips-head screwdriver to remove 4pcs
screws for unlocking the joystick key board with the
S6
rear cover. Tear off the joystick key tapes and release
the joystick key board from the hook of the rear cover.
(No.1~4 screw size=M2x0.2, Torque=0.8
0.5kgfxcm)
±
0.2kgfxcm)
±
1
2
3
4
Advertisement
