Advertisement
Move the assembled rear cover close to the
panel unit, then connect light bar cable to the
connector of the power board, then connect the
S18
power key cable, joystick key cable and USB FFC
cable to the connectors of interface board. Put
down the rear cover and push the rear cover for
mechanisms engagement.
Use a Philips-head screwdriver to tighten 4pcs
screws for locking the rear cover with the assembled
S19
unit. Paste 2pcs labels on the specific positions.
(No.1~4 screw size=M4x10; Torque=9
2
4
4. Disassembly and Assembly Procedures
0.5kgfxcm)
±
3
1
Take a stand base close to the monitor. Fit the two
tabs on the upper part of the stand into the grooves on
S20
the back of the monitor, and then lower the stand so
that the monitor mounting area snaps onto the stand.
Lift up the monitor to checking the gap between the
front bezel with panel module , then provide power
supply and a video signal to the monitor
S21
the monitor for functionality check. Stick an energy
label on top left bezel of the monitor for European
region; Stick an energy label on top right bezel of the
monitor for Australia and New Zealand.
, then turn on
Advertisement
