Connecting The Scxi-1141/1142/1143 Module To A Daq Device For Multiplexed Scanning In A Pxi Combination Chassis; Figure 2-2. Connecting The Scxi Modules For Multiplexed And Parallel Mode - National Instruments SCXI-1141 User Manual

4
®
1 DAQ Device
Connecting the SCXI-1141/1142/1143 Module to a DAQ Device for
Multiplexed Scanning in a PXI Combination Chassis
© National Instruments Corporation
Chapter 2
operation. See the
Module section in this chapter for information on configuring and
testing the installation.
2 Cable 3 Cable Adapter

Figure 2-2. Connecting the SCXI Modules for Multiplexed and Parallel Mode

Use this configuration to multiplex all eight channels of the
SCXI-1141/1142/1143 module into a single channel of the DAQ device
in a combination PXI chassis. You need the following items for
this installation:
• PXI combination chassis with the SCXI modules installed
• National Instruments PXI DAQ device installed in the right-most slot
Consult the PXI chassis documentation, other SCXI module
documentation, and DAQ device documentation for additional
instructions and cautions. You should have already installed the
SCXI-1141/1142/1143 module and any other SCXI modules in the
Installing and Configuring the SCXI-1141/1142/1143 Module
Configuring and Testing the SCXI-1141/1142/1143
3
4 SCXI Chassis Power Switch
2-7
1
2
SCXI-1141/1142/1143 User Manual