Table of Contents
Advertisement
Description of the device
The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page
Illustration A
Transport wheel
1
Storage for spray lance
2
Storage / parking position for high-pressure gun
3
Power Control spray lance dirt grinder for stubborn
4
dirt, pressure level: HARD
Click-Vario Power Power Control spray lance for the
5
most common cleaning tasks, pressure levels:
HARD / MEDIUM / SOFT / MIX
Power Control high-pressure gun
6
Clamp for connecting / disconnecting the high-pres-
7
sure hose
High-pressure gun lever
8
High-pressure gun lock
9
Trigger "0/OFF" / "I/ON"
10
Mains connection with mains plug
11
Storage hook for power cord
12
Carrying handle
13
Transport handle, telescoping
14
Quick coupling for high-pressure hose
15
Type plate
16
High-pressure hose
17
Water connection with integrated sieve
18
Detergent suction hose
19
Water connection coupling
20
**Garden hose with commonly available coupling
21
–
Fabric reinforced
–
Diameter of at least 1/2 inch (13 mm)
–
Length at least 7.5 m
*Washing brush, suitable for working with deter-
22
gents
*Foam nozzle for powerful detergent foam
23
*Detergent container
24
* optional, ** zusätzlich erforderlich
Safety devices
CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
Power switch
The power switch prevents unintentional operation of
the device.
High-pressure gun lock
The lock locks the lever of the high-pressure gun and
prevents the device from starting unintentionally.
Auto-stop function
If the lever of the high-pressure gun is released, the
pressure switch turns off the pump and the high-pres-
sure jet stops. The pump switches on again when the le-
ver is pressed.
Symbols on the device
Do not aim the high-pressure jet may at per-
sons, animals, live electrical equipment or
the device itself.
Protect the device against frost.
The device may not be connected to the
public drinking water network.
For the illustrations, refer to the graphics page.
Fit the supplied loose parts onto the device before start-
ing up the device.
Fitting the wheels
1. Fasten and secure the wheels to the device.
Illustration B
Installing the handles
1. Attach the transport handle.
2. Attach the carrying handle.
Illustration C
Installing the water connection coupling
1. Screw the water connection coupling onto the water
connection on the device.
Illustration D
Initial startup
1. Place the device on a flat and level surface.
2. Insert the high-pressure hose into the quick coupling
until it audibly latches into place.
Illustration E
3. Press the clamp for the high-pressure hose together
and pull out of the high-pressure gun.
Illustration F
4. Insert the high-pressure hose into the high-pressure
gun.
5. Press the clip in until it latches into place.
6. Check for a secure connection by pulling on the
high-pressure hose.
7. Plug the mains plug into a mains socket.
For the connection values, see the type plate or chapter
Technical data.
Observe the water distribution company regulations.
ATTENTION
Damage through contaminated water
Contamination in the water can damage the pump and
the accessories.
KÄRCHER recommends using the KÄRCHER water fil-
ter for protection(special accessory, order number
4.730-059).
Connection to the water line
ATTENTION
Hose coupling with Aquastop on the water connec-
tion of the device
Damage to the pump
Never use a hose coupling with Aquastop on the water
connection of the device.
You can use an Aquastop coupling on the tap.
English
Assembly
Water supply
7
Advertisement
Table of Contents
