Table of Contents
Advertisement
Setting the time window for cost-
effective charging
1.
Press the button.
2.
"Charging"
3.
"Charging mode"
4.
"Charging in time slot"
5.
Select the desired setting.
Target charge
Principle
A percentage target value can be set when
charging the high-voltage battery.
If a lower target value is set, the charging time
can be shortened.
General
Charging with a set charging target is recom‐
mended in particular when charging the vehicle
at a DC charging station. To make optimum use
of the function, a target value of 80 per cent is
recommended.
Setting the target charge
1.
Press the button.
2.
"Charging"
3.
"Charging target"
4.
Select the desired setting.
Permissible DC charging volume
If the vehicle is charged at a DC charging station,
the noise emissions that occur during charging
process can be restricted in order to comply with
local noise regulations, for example. Restricting
Online Edition for Part no. 01405A38CB9 - VI/21
Charging vehicle
the noise emissions may result in longer charg‐
ing times.
1.
Press the button.
2.
"Charging"
3.
"Fan loudness"
4.
Select the desired setting.
Stopping charging process
When the vehicle is charged using a
Mode 2 charging cable or a Mode 3 charging ca‐
ble, the charging process will be interrupted
when the vehicle is unlocked. The charging proc‐
ess will then be continued automatically after a
short period of time or when the vehicle is
locked.
The charging process can be terminated at any
time by removing the charging cable, and re‐
sumed at a later point by connecting the charg‐
ing cable. For example to allow other consumers
to use the power supply in the meantime, or to
avoid having several high power consumers con‐
nected at the same time.
For further information:
Removing, see page 326.
Resuming charging process
If charging process is interrupted, for example, by
unlocking the vehicle or due to a temporary
power failure, charging process is automatically
continued after the interruption.
When the vehicle is charged at a public charging
station, the charging process may not continue
automatically after an interruption.
Ending charging process
1.
Disconnect the charging cable from the vehi‐
cle.
Removing, see page 326.
2.
Stow the charging cable if necessary.
MOBILITY
329
Advertisement
Table of Contents
