Table of Contents
Advertisement
Programming the integrated universal
remote control
Operating requirements
The battery in the hand-held transmitter must be
fully charged during programming to ensure the
integrated universal remote control will have the
optimum range.
Programming individual buttons
1.
Park your vehicle within the range of the radio
remote-controlled system.
2.
Switch on standby state.
3.
Select desired button on the interior mirror:
▷
Program available button:
Press the button.
▷
Program already assigned button:
Press and hold the button for approx.
20 seconds.
The LED on the interior mirror flashes orange
slowly.
4.
Hold the hand-held transmitter for the re‐
mote-controlled system approx. 2.5 to 30 cm,
1 to 12 in away from the buttons on the inte‐
rior mirror.
The distance required depends on the hand-
held transmitter.
5.
Press and hold the button on the hand-held
transmitter.
6.
The LED can illuminate in various ways:
▷
The LED is illuminated green: program‐
ming is complete.
Release button.
▷
The LED flashes green rapidly: the hand-
held transmitter was detected but pro‐
gramming is not complete.
Press and hold the button on the interior
mirror for approx. 2 seconds. Perform this
procedure three times.
If the integrated universal remote control
remains non-operational, continue with
Online Edition for Part no. 01405A38CB9 - VI/21
Interior equipment
the special features for alternating-code
radio systems.
▷
LED does not illuminate green after
60 seconds: programming not completed.
Repeat steps 3 to 5.
Special instruction for alternating-code
radio systems
For systems with an alternating-code radio sys‐
tem, the integrated universal remote control and
the system must also be synchronised.
Refer to information on synchronisation in the
operating instructions of the remote-controlled
system.
1.
Program the desired button on the interior
mirror.
2.
Locate and press the synchronising button
on the remote-controlled system, for exam‐
ple, on the garage door.
The next step must be carried out within ap‐
proximately 30 seconds.
To make synchronisation easier, enlist the as‐
sistance of a second person.
3.
Press and hold the programmed button on
the interior mirror for approx. 3 seconds.
Repeat this step as needed up to three times
to end synchronisation. When synchronisa‐
tion is completed, the programmed function
is performed.
Operation
After programming, the remote-controlled sys‐
tem can be operated with the button on the inte‐
rior mirror.
Press and hold the desired button of the remote-
controlled system within range until the function
is triggered.
The LED on the interior mirror is continuously il‐
luminated green during the transmission of the
radio signal.
CONTROLS
293
Advertisement
Table of Contents
