Trouble-Shooting And Maintenance - Weslo gym 3000 User Manual

All manuals and user guides at all-guides.com

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the training system. Replace any worn parts immediately. The
training system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
15
Adjustment
Woven cable, the type of cable used on the training
Screw
system, can stretch slightly when it is first used. If
there is slack in the cables before resistance is felt,
23
the cables should be tightened. Locate the adjust-
ment sleeve and adjustment screw near the lower
end of the Short Cable (23). Loosen the adjustment
Ball
screw. Pull the end of the Short Cable until there is no
Adjustment
slack in the cables. Slide the adjustment sleeve and
15
Sleeve
the ball against the indicated 3 1/2" Pulley (15).
Retighten the adjustment screw. Make sure that the
cables are not too tight, or the top weight will be lifted
off the weight stack.
23
Additional slack can be removed by locating the indi-
cated 5/16" Nylon Locknut (3) near the upper end of
the Front Upright (42). To tighten the cables, hold the
5/16" x 3 1/4" Bolt (35) and turn the Nylon Locknut
clockwise.
3
35
42
Note: Inspect all cables before each use. If a cable tends to slip off the pulleys often, the cable may have
become twisted. Remove the cable and re-install it.
If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.
Replace all cables every two years.
18