Advertisement
A
CLI
CCESS THE
Access the AOS CLI via the CRAFT port or a Telnet or SSH session. To establish a connection to the NetVanta
unit CRAFT port, you need the following items:
■
PC with VT100 terminal emulation software
■
Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate interface for
your terminal or PC communication port on the other end.
g
NOTE
You can find VT100 terminal emulation software on most PCs by navigating to Start > Programs >
Accessories > HyperTerminal > HyperTerminal. When you have opened a HyperTerminal session, enter the
settings described in Step 4.
1. Connect the DB-9 (male) connector of your serial cable to the CRAFT port on the back panel of the unit.
2. Connect the other end of the serial cable to the terminal or PC.
g
NOTE
Many PCs do not come with a standard serial port. A universal serial bus (USB) to serial adapter can be used
instead. The drivers for the USB to serial adapter must be installed according to the manufacturer's instruc-
tions. If the USB to serial adapter is not properly installed on your PC, you will not be able to communicate with
the AOS unit and you should seek support from the USB to serial adapter manufacturer.
3. Insert the connector of the provided power cord into the power interface on the back panel of the unit,
and plug the cord into a standard electrical outlet. Refer to the
Installation Guide
4. Once the unit is powered up, open a VT100 terminal session using the following settings: 9600 baud, 8
data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the AOS CLI.
5. Enter enable at the > prompt. Enter the enable password when prompted. The default password is
password.
You can also access the CLI from a Telnet client. In order to do this, you must know the IP address of the AOS
device. If you do not know the unit's IP address, you must use the CRAFT port to access the CLI. To access the
CLI using a Telnet client, follow these steps:
1. Connect the NetVanta unit to your PC using an Ethernet cable connected to the GIG 0/1 port on the front
of the device or connect the NetVanta unit to an existing network that supports DHCP using the GIG 0/1
port on the front of the device.
2. Open a Telnet client on your computer and enter 10.10.10.1. If your unit received an IP address from a
DHCP server or you have changed your unit's IP address, you will need to enter that address.
3. Enter enable at the > prompt and enter the enable password when prompted. The default password is
password.
C
CLI C
OMMON
The following are common CLI commands and tips for getting started with the CLI.
■
Entering a question mark (?) shows contextual help and options. For example, entering ? at the prompt will
show all commands available from that prompt.
■
To view interface statistics, enter show interface <interface type> <interface number>.
■
To view the current configuration, enter show running-config.
■
To view all the IP addresses currently configured, enter show ip interface brief.
■
To view the AOS version, serial number, and other information, enter show version.
■
To save the current configuration, enter write.
M
C
ANUALLY
ONFIGURING THE
g
NOTE
The configuration parameters used in the examples outlined in this document are for instructional purposes
only. Please replace all underlined entries (example) with your specific parameters to configure your appli-
cation.This step is unnecessary if the unit's IP address has been configured automatically using DHCP
(NetVanta 6250 Series products only).
2
at
https://supportforums.adtran.com
OMMANDS
NetVanta 6240/6250 Series Hardware
for more details.
U
'
IP A
NIT
S
DDRESS
61700202G1-13D
Advertisement
