Kohler 10257T Installation Instructions

INSTALLATION INSTRUCTIONS
安装说明书
10257T 11621T 11639T 11640T 11641T 11642T 10257T-A
18526T 18527T 18528T 18529T 18530T 14788T 12861T
安装之前
所有的资料是按最新出版的产品资料编写而成。科勒
公司保留任何时候不经通知即可改变产品特性、包装
或产品可供类型的权利。
说明书包括重要的安装、保养及清洁方面的内容，请
把这些资料交给用户阅读。
注意事项：
1.一定要先彻底冲洗供水管以清除管道中的杂质。
2.花洒最高工作压力：0.5MPa(5bar)。水压超过
0.5MPa(5bar)须安装减压阀。花洒最高工作温度及
环境温度：60ºC。请特别注意花洒同花洒连接的臂
管须远离浴霸，否则可能损坏花洒及其密封件，甚至
对使用者造成伤害。
安装尺寸
G1/2˝ G1/2˝
10257T 11621T 11639T 11640T 11641T 11642T 18526T
/10257T-A
安装步骤
对于11621T/11640T/11642T/
18526T/18527T/18528T/18529T/
18530T
将限流器(1)(18528T已带有限流器，
无需额外安装)如图示方向塞入花洒(2)
进水口，用垫片(3)(注意：对于 18527T
& 18528T
，使用5mm厚垫片。)连接花
洒与花洒软管(4)。
1064228-2-E
G1/2˝ G1/2˝
G1/2˝ G1/2˝
BEFORE YOU BEGIN
All information is based on the latest product
information available at the time of publication. Kohler
Co. reserves the right to make changes in product
characteristics, packaging, or availability at any time
without notice.
Please leave these instructions for the consumer.
They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove
debris.
2. The highest working pressure for spray is 0.5MPa
(5bar). If it exceeds 0.5MPa(5bar), a pressure reducer
is needed. The highest water and environment
temperature is 60ºC. Please keep handspray, shower
head and the shower arm away from heater, or it may
become damaged and cause injury to the user.
ROUGH-IN DIMENSIONS
G1/2˝
G1/2˝ G1/2˝
18527T 18528T 18529T
2
1
3
4
G1/2˝ G1/2˝ G1/2˝
18530T 14788T
INSTALLATION
For 11621T/11640T/11642T/
18526T/18527T/18528T/18529T/
18530T
Put the restrictor(1)(The restrictor of
18528T has been inside, needn't manual
install) into the handspray(2) inlet as
shown. Connect shower hose(4) to
handspray with washer(3)(NOTE: For
18527T & 18528T, use the washer of
thickness 5mm. ).
Handspray
手持花洒
手持花洒
88
G1/2˝
12861T
1