Using Modules; How To Fit And Remove Modules; How To Remove A Front-Loadable Module - Agilent Technologies 8163A User Manual

Installation and Maintenance
CA U TI ON
210
• that the load is as close to your body as possible,
• when carrying, you never arch your spine backwards, and
• that you can cope with the weight of your load.

Using Modules

How to Fit and Remove Modules

You can use two types of module:
• Front-loadable modules - these modules fit in the four module slots at the front
of the Agilent 8164A Lightwave Measurement System or the two module slots
at the front of the Agilent 8163A Lightwave Multimeter System or the 17
module slots at the front of the Agilent 8166A Lightwave Multichannel
System.
• Back-loadable modules - these tunable laser source modules fit in the large
module slot at the rear of the Agilent 8164A Lightwave Measurement System.

How to Remove a Front-Loadable Module

Do not use the electrical or optical connectors to pull the module out of the
instrument, as this can cause damage to the connectors.
Make sure that the line power is switched off before you remove a module.
Figure 159 How to Remove a Front-Loadable Module
1 Lift the catch at the bottom front of the module.
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement
System, & Agilent 8166A Lightwave Multichannel System, Fourth Edition
Using Modules