Mounting The Device To A Rack - Siemens SIMATIC NET RUGGEDCOM RS400 Installation Manual

Installing the Device
2.3.2 Mounting the Device to a Rack
Removing the Device
To remove the device from a DIN rail, do the following:
1.
2.
2.3.2

Mounting the Device to a Rack

For rack mount installations, the RUGGEDCOM RS400 can be equipped with rack
mount adapters pre-installed at the front or rear of the chassis. Additional adapters
are provided to further secure the device in high-vibration or seismically active
locations.
To secure the device to a standard 48 cm (19 in) rack, do the following:
Note
The device can be ordered with the communication ports located at the front or rear
of the device. Placing the ports at the rear allows all data and power cabling to be
installed and connected at the rear of the rack.
10
Loosen or remove the #8-32 lock screws on both sides of the device.
2
2
1
Panel/DIN Rail Adapter
1
DIN Rail
2
Screw
3
Figure 2.2 Removing the Device from a DIN Rail
Lift the device off the DIN rail.
RUGGEDCOM RS400
Installation Manual, 01/2021, C79000-G8976-1016-11
1
3
2