Advertisement
Sportsound SSR-AM Quick Guide
1
2
3
4
1. POWER INPUT – Connect included 12 VAC wallpack transformer.
Use the tab above the power jack as a strain relief for the cord.
2. CHASSIS GND LFT – This switch can reduce the humming effect of
a ground loop. Use a pen or small pointed object to toggle the
switch in/out (on/off).
3. SETUP SELECTOR – These DIP switches are factory set for the most
common operation requirements, but they can be changed if
needed. Refer to DIP Switch Settings at right for more information.
4. OUTPUT PAD – Enable this setting ONLY IF the mix output is going
into another mixing console. If the mix output is going directly to
a sound system, leave this switch off (default). Use a pen or small
pointed object to toggle the switch in/out (on/off).
5. MIX OUTPUT – XLR output jack to audio system (or another mixer)
6. PHONES OUT – 1/4" & 1/8" jack for headset and/or headphones
7. MIC INPUT – XLR input jack for headset (or optional microphone)
DD3638236
Rev 01
25 June 2018
5
6
7
201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
DIP Switch Settings
1. N/A (Not Used)
2. MUSIC IN PHONES:
ON (default) = mic and music
signals go to phones out jacks
OFF = only mic signal goes to
phones out jacks
3. LIMITER ON/OFF:
ON (default) = output level is limited to protect the sound system
OFF = output level is not limited – improper use can damage
sound system!
4. LIMIT THRESHOLD:
+4 (default) = allows the sound system to reach full output while
protecting against improper use and large signal spikes
-6 = reduces the output capability while providing the greatest
protection against improper use of the sound system
5. DUCKER ON/OFF:
ON (default) = music level automatically reduces when mic signal
is sensed; music level gradually goes back up when mic is off
OFF = music will not change volume level when speaking into mic
6. DUCKING LEVEL:
-15dB (default) = the mic will be louder than the music, but music
can still be heard in the background
-70dB = music will be completely quiet when the mic is active
7. N/A (Not Used)
8. PHANTOM POWER:
ON (default) = supplies 12VDC to mic input to power condenser
microphones; the provided headset requires phantom power
OFF = select when using dynamic microphones
800.325.8766
Page 3 of 4
Advertisement
