STERWINS 40ECS1-2000.1 Assemby - Use - Maintenance Manual page 26

RU
Problems
KZ
EN
Excessive noise
Over-
consumption
Oil leak
Chain breakage
Chain guide
breakage
Chain does not
stop on released
trigger
Probable causes
Nuts / screws are not well
tight
The blade is not enough set
There is a leak of oil due
to a defective assembling
(drilled pip/bad connection)
The lubricant oil continues
to flow by capillarity
The chain is too tight
The chain is not lubricated
enough
The chain is not lubricated
enough
The chain is not lubricated
enough
The chain is wasted
The blade cover is not well
put
The trigger is blocked on
ON position
The guide has been stuck
on a branch
Solutions
Screw the nut(s) / screw(s)
Screw the nut(s) / screw(s)
Find the leak location and
replace the part by a new one
"Check with the after sales
service if the oil pump is not
damaged. Otherwise it's
normal,
let the chainsaw cool while
protecting the ground
(cardboard, towel ...)"
Unscrew the chain tightening
screw
Check if the oil tank is not
empty and fill it
The oil pump is defective,
change it
Check the setting of the oil
consumption and adjust it
Remove it and change it by a
new one
Remove the cover and pay
intention to put on the good
position and tight it enough
Remove the trigger cover and
replace it by a new one
Pay attention to initiate the
cup by 3-4 cm blow the branch
and then cut it from above
26
Qualification
required
-
After sales
service
-
-
After sales
service
-
-
After sales
service