Table of Contents
Advertisement
B Check of remote controller and indoor electronic control P.C. board
*Check if the remote controller is exclusive for this air conditioner.
MS-CP13VA
Press OFF/ON (stop/operate) button
on the remote controller.
Is LCD display on the remote controller
visible?
Yes
Remove the batteries, then set them back
and press RESET button. (Refer to 9-1.4.)
Check if the unit operates with the remote
controller.
Does the unit operate with the remote
controller?
Yes
OK
MS-CP18VA MS-CP24VA
Press OFF/ON (stop/operate) button
on the remote controller.
Is LCD display on the remote controller
visible?
Yes
Remove the batteries, then set them back
and press RESET button. (Refer to 9-1.4.)
Check if the unit operates with the remote
controller.
Does the unit operate with the remote
controller?
Yes
OK
OBH782A
Replace the batteries. (Refer to 9-1.4.)
No
(Not clear)
Turn ON a radio to AM and press OFF/
ON (stop/operate) button on the remote
No
controller. *1
Is noise heard from radio?
Yes
Are there any fluorescent lights of
inverter or rapid-start type within the
range of 1 m? *2
No
Replace indoor electronic control P.C.
board.
Replace the batteries. (Refer to 9-1.4.)
No
(Not clear)
Turn ON a radio to AM and press OFF/
ON (stop/operate) button on the remote
No
controller.
*1
Is noise heard from radio?
Yes
Are there any fluorescent lights of
inverter or rapid-start type within the
range of 1 m?
*2
No
Measure the voltage between power
monitor receiver SW P.C. board connec-
tor CN20A No.2(+) and No.3(-) when the
remote controller button is pressed.
Is the voltage approximately 4 V DC?
No
Replace power monitor receiver SW P.C. board.
31
*1 Look at the image of the signal transmitting section of
the remote controller through the monitor of a digital
camera or a camera phone. It is normal if the LED of
the signal transmitting section lights up when the OFF/
ON (stop/operate) button on the remote controller is
pressed. However, it may be difficult to see the illu-
minated LED of the signal transmitting section with a
smartphone camera.
*2 If the inverter fluorescent light is turned on when the
room is cool, the unit may have difficulty receiving the
signal from the remote controller or may not be able to
operate with it; if the inverter fluorescent light is turned
on when the room is warm, the unit may be able to
operate with the remote controller.
Replace the remote controller.
No
• Reinstall the unit away from lights.
• Attach a filter on receiving part.
Yes
*1 Look at the image of the signal transmitting section of
the remote controller through the monitor of a digital
camera or a camera phone. It is normal if the LED of
the signal transmitting section lights up when the OFF/
ON (stop/operate) button on the remote controller is
pressed. However, it may be difficult to see the illu-
minated LED of the signal transmitting section with a
smartphone camera.
*2 If the inverter fluorescent light is turned on when the
room is cool, the unit may have difficulty receiving the
signal from the remote controller or may not be able to
operate with it; if the inverter fluorescent light is turned
on when the room is warm, the unit may be able to
operate with the remote controller.
Replace the remote controller.
No
• Reinstall the unit away from lights.
• Attach a filter on receiving part.
Yes
Replace indoor electronic control P.C.
Yes
board.
Advertisement
Table of Contents
