Maintenance - MG TR-EVO Instructions For Use Manual

= (7 + EVEN )
73
= (7 + ODD )
74
= (8 + NONE )
81
= (8 + 2stop )
82
= (8 + EVEN )
83
= (8 + ODD )
84
code 21 Serial bus speed. As the previous parameter adapts communication to others connected
devices.
= 19200b/s
19
= 2400b/s
24
= 4800b/s
48
= 9600b/s
96
code 22 Device bus addres. Selects the number of peripheral devices that the TR-evo assumes in
the communications bus, its function is to allow multiple devices to connect to the same
communications port without interfering with each other. Device address 58 is reserved and
must not be used on the bus that contains TR-evo devices.
On code 23, the display shows
ret
status by pressing the
2 3
The
≡

Maintenance

ATTENTION: before carrying out any maintenance operation, ensure you have
disconnected power.
The temperature controller does not require particular maintenance, however you are advised to
every now and then check all the connections are tight, especially those going from the
transformer to the heating element that carry very high current peaks.
The front of the keypad and the numerical display should be cleaned with a clean, wet cloth and
neutral detergent. The dirt on all the other parts should be removed with compressed air.
18
key.

key returns you to the beginning parameter 11 display.
and allows you to exit parameter programming
rEt