Operating Modes - MG TR-EVO Instructions For Use Manual

Pressing the key again
≡
access the equipment configuration is enabled (for information on the configuration, refer to the
relevant chapter).
Press the key again to display the temperature read on the heating element again.
≡
For test purposes, you can press the

Operating modes

The temperature controller can be configured with various operating modes.
In brief, the available modes are:
temperature temperature
5 5
3 3
4 4
2 2
1 1
1 1
temperature
5
3
4
2
12
is displayed on greater display line and
cfg
key to force activation of the heating cycle.
interactive:
by doing so, the pre-heating input allows you to activate
temperature control at the pre-heating temperature (2) and the
start input allows you to activate the temperature control at the
heating temperature (4). The start input has priority over the
pre-heating input.
On reaching the working temperature (3), the active cycle
time time
output activates.
PREHEATH
On deactivating the heating input temperature goes low and
active cycle output deactivates.
START
CICLE
Always on:
in this mode, temperature control is always on and
continuously adjusts the pre-heating temperature. Activating
the start input, the adjusted temperature changes to the heating
temperature.
On deactivating the heating input temperature goes low and
time
active cycle output deactivates.
START
CICLE
on lower display and
00