Prime Inventions AquaAvanti Inline Manual page 15

4. INSTALLATION OF WATER INLET / OUTLET
1. Plug in the white hose for the water inlet. (See arrow on the top which shows
the water flow direction).
2. Next step is to plug in the other end of the hose into the T-Adapter.
3. Ready Installation for water inlet
Please install now your faucet for filter water (or three way faucet) according to
the faucet manual. To connect the faucet to the filter system your should put on
the water faucet adapter (included) on the 3/8" male thread of the faucet.
4. Now plug in the hose in the water outlet (on the right side of the head)
5. and the other side to the 3/8" adapter of the faucet.
6. Please push the hose in all the way to the stop.
Please take care to push the hose all the way to the stop in order to avoid leaking. For
shortening of the hoses please use a proper tool. Please do not use a wire cutter or
tong. You can use a sharp knife and make sure to cut straight. If you cut it angular it
will cause leaking.
1
4
!
ATTENTION
2
5
3
6
15
15