Table of Contents
Advertisement
Quick Links
DESK ASSEMBLY IS STEP 1
A A
E E
29X
29X
#2 Phillips screwdriver
DISCLAIMER
•
Two people are recommended for the assembly of this product.
•
Use hardware provided and tools recommended to avoid any product faults.
•
Always assemble product on a clean soft surface to avoid scratching.
B B
C C
29X
2X
#2 Robertson
ASSEMBLY INSTRUCTIONS
IF DESK IS 84" + EXTRA SUPPORT PIECES
ARE REQUIRED
D D
W-01DxxxxS
H
I
Extra hardware may be included
1
Advertisement
Table of Contents
Related Manuals for Belair W-01D S Series
Summary of Contents for Belair W-01D S Series
- Page 1 W-01DxxxxS ASSEMBLY INSTRUCTIONS DESK ASSEMBLY IS STEP 1 PARTS INCLUDED IF DESK IS 84” + EXTRA SUPPORT PIECES ARE REQUIRED HARDWARE INCLUDED Extra hardware may be included TOOLS REQUIRED #2 Phillips screwdriver #2 Robertson DISCLAIMER • Two people are recommended for the assembly of this product. •...
- Page 2 W-01DxxxxS STEP 1 Connect desk top A and left gable B as shown. Fasten pins and cams. If desk is 84” + move to STEP 3. STEP 2 Lay back D flat and lower top and gable onto back. Do not fasten pins and cams until next step.
- Page 3 W-01DxxxxS STEP 3 If desk is 84” + attach desk support gable I Fasten all pins and cams. STEP 4 Lay desk back D flat and lower top and gables onto back as shown. Do not fasten pins and cams. STEP 5 If desk is 84”...
- Page 4 W-01DxxxxS STEP 6 Attach right gable C . Fasten all pins and cams and lift unit right side up. STEP 7 Assemble transaction top E Fasten pins and cams. STEP 8 See W-01S - Waterfall instructions to finish off assembly.
- Page 5 W-01Wxxxx ASSEMBLY INSTRUCTIONS WATERFALL ASSEMBLY IS STEP 2 PARTS INCLUDED HARDWARE INCLUDED TOOLS REQUIRED #2 Phillips Screwdriver #2 Robertson screwdriver DISCLAIMER • Two people are recommended for the assembly of this product. • Use hardware provided and tools recommended to avoid any product faults. •...
- Page 6 W-01Wxxxx STEP 1 Connect waterfall top F and back G as shown. Fasten pins and cams. STEP 2 Remove backing from double sided tape on top of waterfall. Position waterfall on center of transaction top and secure waterfall with screws through back of unit as shown. Use cover caps to cover any visible cams and screws.
Need help?
Do you have a question about the W-01D S Series and is the answer not in the manual?
Questions and answers