Summary of Contents for Belair Captain's Bed with Extra Single BOP 11
Page 1
BOP 11 Captain's Bed with Extra Single SHEETS: 1 - Cover Sheet 2 - Captain's Bed Assembly 3 - Large Frame Assembly 4 - Bed Frame Assembly 5 - Single Bed Assembly 6 - Stair Assembly 7 - Unit Assembly TWO PEOPLE ARE RECOMMENDED FOR THE ASSEMBLY OF THIS UNIT.
Page 2
BOP 11 Captain's Bed Assembly 16+1 16+1 1 Head End 1 Foot End Chicago Bolt Metal Dowel 5/8" Screws Large L Bracket Cover Cap Allen Key 4 Rail Tools Required: • For a left hand configuration assemble unit as shown below. For a Right Hand configuration switch the •...
Page 3
BOP 11 Large Frame Assembly Tools Required: • #3 Phillips Screwdriver 2 Stringer 24+1 KD 24+1 Pin • Insert KDs and pins into all appropriate hole. Ensure the arrow on the KDs points towards the edge. • Lay the top upside down as shown below to start assembly. •...
Page 4
BOP 11 Bed Frame Assembly Tools Required: • #3 Phillips Screwdriver • Insert KDs and pins into appropriate holes to start. Ensure the arrow on the kd points towards the edge. • Use cover caps to cover KDs on the inside of 10+1 10+1 the frame.
Page 5
BOP 11 Single Bed Assembly 1 Head End 1 Foot End 2 Side Panel 1 Middle Support 3 Glide Support 10 Bed Slat Tools Required: • Allen Key (provided) • Flat Head Screwdriver • Electric Drill • #1 Robertson Drill Bit •...
Page 6
BOP 11 Stair Assembly Tools Required: • Allen Key (provided) • Flat Head Screwdriver • Electric Drill • #2 Robertson Driver Bit Washer Head 1 Staircase Gable Stair Chicago Bolt Metal Dowel Cover Cap Screw Remove all drawer boxes and secure staircase gable (1) as shown below. •...
Page 7
BOP 11 Assembly Instructions Dresser Large Frame Staircase Bed Frame Captain's Bed Single Bed STEP 1 STEP 2 Tools Required: • Electric Drill • #2 Robertson Drill Bit * Assemble the large frame, bed frame and dresser * Line staircase up to bed, ensure the back of the as shown below for a Left Hand configuration.
Need help?
Do you have a question about the Captain's Bed with Extra Single BOP 11 and is the answer not in the manual?
Questions and answers