Using As A Photo Frame; Preparing The Remote Control - Sony S-Frame DPP-F800 Operating Instructions Manual

Using as a photo frame

Preparing the remote
control
The supplied lithium battery (CR2025) has
already been inserted into the remote control.
Pull out the protective sheet before use as
shown in the figure.
Using the remote control
Point the top end of the remote control towards
the remote sensor on this unit.
GB
20
Protective sheet
Remote
sensor
Replacing the battery of the
remote control
If the remote control stops working, replace the
battery (CR2025 lithium battery) with a new
one.
1
Press the tab in.
2
Pull the battery holder out.
3
Insert a new battery and slide the
battery holder back into the remote
control.
Insert the battery so that "+" is facing
upwards.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
Notes
• When the lithium battery becomes weak, the
operating distance of the Remote control may
shorten, or the Remote control may not function
properly. In this case, replace the battery with a
Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.
• Using a battery other than the specified one may
result in the battery rupturing.