Canon VB-C50I User Manual page 50

Setting Camera Control, Image Size and Quality (Camera and Video)
3 "Home Position"
Specify a home position for the camera.
"Pan"
Set the pan position of the camera.
"Tilt"
Set the tilt position of the camera.
"Zoom"
Set the value for the camera's angle of zoom.
"Brightness"
Set the target value for the camera's auto exposure feature. Select "Brighter" if the picture
is too dark due to backlight or other factors.
"Return to Home Position when nobody has a control privilege"
When this option is checked and the home position is specified, the camera is moved to its
home position if there is no request for a control privilege.
Do not attempt to manually change the camera head angle.
If the camera head is accidentally moved by hand or other objects
Note
touching it, be sure to perform one of the following ;
• initialize the camera head position (→ P.7-23).
• restart the VB-C50i/VB-C50iR by turning the power supply OFF
then ON again.
The operating range of the camera heads on the VB-C50i/VB-C50iR is shown below.
Tip
4 "Apply View Restriction"
If you check the "Apply View Restriction" option, the settings below are enabled. Use this
setting to prevent clients from seeing certain camera angles. Using the VB Administration
Tools is a convenient way to set the view restrictions (→ P.4-12).
"Upper value, Lower value, Left value, Right value"
Set the extent of the field of view provided to users. (Specify settings so that the upper
value is greater than the lower value and the left value is less than the right value.)
"Telephoto, Wide-angle"
Set the zoom angles provided to users. (Specify settings so that the telephoto setting is
less than or equal to the wide-angle setting.)
5 "Wide Converter"
When you have attached a wide converter to the camera, be sure to select "Used". This setting
is only available for the VB-C50i.
* When the Wide Converter is set to "Used", the infrared light cannot be used (→ P.4-70).
3-10
+90°
+100°
–100°
–30°
+10°
+170°
–170°
–90°