Warn 70924 Installation Instructions

Multi-mount 4.0ci winch for kawasaki mule 3000 & 3010 rear receiver

As you read these instructions, you will see NOTES, CAUTIONS, and WARNINGS. Each message has a

specific purpose. NOTES are additional information to help you complete a procedure. CAUTIONS are

safety messages that indicate a potentially hazardous situation which, if not avoided, may result in minor or

moderate injury. A CAUTION may also be used to alert against unsafe practice or possible equipment

damage. WARNINGS are safety messages that indicate a potentially hazardous situation, which, if not

avoided could result in serious injury. CAUTIONS and WARNINGS identify the hazard, indicate how to avoid

the hazard, and advise of the probable consequence of not avoiding the hazard. PLEASE WORK SAFELY!

Before You Begin

This kit is compatible with WARN's line of ATV winches. Winch sold separately. Please read WARN's

Winching Technique guide provided with the winch prior to use of this product.

Table of Contents

Parts List ....................................................... 2

II.

Tools Required .............................................. 2

III.

Rear Receiver Installation ............................. 3

IV.

Electrical Connections.....................................4

Maintenance/Care ......................................... 4

WARN® INDUSTRIES

INSTALLATION INSTRUCTIONS

MULTI-MOUNT 4.0CI WINCH

Applications: KAWASAKI MULE 3000 & 3010

Winch and Equipment Damage

This mount is designed for a 4000 lb. winch.

Using a higher capacity winch may cause personal

injury or severe damage to the mount or ATV

Read installation and operating instructions thoroughly

PAGE 1

Part Number: 70924

Rear Receiver Installation

CAUTION

71047A0

Table of Contents

Need help?

Do you have a question about the 70924 and is the answer not in the manual?

Page 1 PLEASE WORK SAFELY! Before You Begin This kit is compatible with WARN’s line of ATV winches. Winch sold separately. Please read WARN’s Winching Technique guide provided with the winch prior to use of this product.
Page 2 Rear Receiver 68593 Brkt Rear Receiver • Wrenches: 12 mm, 13mm, 1/2” 22502 5/16-18 x 2 1/2 Hex Cpsc 69308 U-Bolt 5/16-18 x 2 x 2 11/16 2002 5/16-18 Locking Hex Nuts 1324 5/16 Flat Washer WARN® INDUSTRIES PAGE 2 71047A0...
Page 3 10-12 ft-lb (16 N-m). Rear receiver mounting is now complete move to section VI, entitled “Maintenance/Care”. Figure 3 Figure 4 Figure 1 WARN® INDUSTRIES PAGE 3 71047A0...
Page 4 WARNING Failure to perform regular inspections and maintenance on the winch, winch mount, and related hardware may result in vehicle damage and operator injury or death. WARN® INDUSTRIES PAGE 4 71047A0...