Lcd Screen - Sony Handycam HDR-CX250E Operating Manual

The Active Interface Shoe has a safety device

for fixing the installed accessory securely. To
connect an accessory, press down and push it to
the end, and then tighten the screw. To remove
an accessory, loosen the screw, and then press
down and pull out the accessory.
When you are recording movies with an

external flash (sold separately) connected to
the accessory shoe, turn off the power of the
external flash to prevent charging noise being
recorded.
You cannot use an external flash (sold

separately) and the built-in flash at the same
time.
When an external microphone (sold separately)

is connected, it takes precedence over the built-
in microphone.
On Wireless Remote Commander
(HDR-PJ260E/PJ260VE/PJ580E/
PJ580VE/PJ600E/PJ600VE)
Remove the insulation sheet before using the

Wireless Remote Commander.
Insulation sheet
Point the Wireless Remote Commander

towards the remote sensor to operate your
camcorder (p. 12).
When no commands have been sent from the

Wireless Remote Commander within a certain
period, the light blue frame disappears. When
you press any of ///, or ENTER again,
the frame appears at the position where it was
displayed last.
You cannot select some buttons on the LCD

screen using ///.
To change the battery of the Wireless Remote
Commander

While pressing on the tab, inset your fingernail
into the slit to pull out the battery case.
GB


Place a new battery with the + side facing up.

Insert the battery case back into the Wireless
Remote Commander until it clicks.
Tab
When the lithium battery becomes weak, the

operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function
properly. In this case, replace the battery with
a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.

LCD screen

Do not apply excessive pressure on the LCD

screen, as it may cause uneven color and other
damage.
If your camcorder is used in a cold place, a

residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of

the LCD screen may heat up. This is not a
malfunction.
To clean the LCD screen
If fingerprints or dust make the LCD screen

dirty, it is recommended that you use a soft
cloth to clean it.
To clean the projector lens (HDR-
PJ260E/PJ260VE/PJ580E/PJ580VE/
PJ600E/PJ600VE)
Wipe the lens gently with a soft cloth such as a

cleaning cloth or glass cleaning cloth.
Stubborn stains may be removed with a soft

cloth such as a cleaning cloth or glass cleaning
cloth lightly dampened with water.