Table of Contents
Advertisement
If the ambient temperature difference
occurs even when the hood is not
operating while the automatic mode
is active, the temperature sensor in
the product will detect the difference
and the product may start operating
at Speed 2 or 3 depending on the
difference. In this case, automatic
mode will be turned off when the
temperature difference is equalized.
Do not use automatic mode when
your hood is not working.
Air cleaning mode (for models B and C)
You can use air cleaning mode to eliminate
the odour in your house during a long time at
low level.
a. Touch the Speed 1 key for more than 3
seconds.
ð Air cleaning mode is activated. The
light of the Speed 1 key flashes
when the air cleaning mode is act-
ive.
b. The air cleaning mode will operate at
Speed 1 for 10 minutes in 1 hour and will
stop for 50 minutes. If you do not switch
off the air cleaning mode, it will remain in
operation for 10 minutes every 1 hour for
24 hours, then stop for 50 minutes.
When air cleaning mode is active, it
is automatically cancelled at the
touch of any key except lamp key.
Your hood continues to operate at
the function of the key you touch.
Aluminium filter fill warning
The light of Speed 2 key flashes after every
100 hours of operation. In this case, you
must clean your aluminium filter. After clean-
ing, the lamp warning of Speed 2 button
does not turn off automatically. When you
touch the speed 2 key for more than 3
seconds, aluminium filter fill warning is reset
and the lamp is turned off.
If the power is cut when the hood
gives aluminium filter fill warning,
then the warning is not cancelled.
When power is available, it continues
to warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the aluminium filter fill
warning, the warning will not appear
for as long as the hood is running.
When you turn off the hood, the fill
warning flashes again.
If you turn off the warning without
cleaning the aluminium filter, the op-
erating time of 100 hours is reset
and it starts over. At the end of the
next 100 hours, your hood warns
again.
Carbon filter fill warning (for products
with carbon filter)
The light of Speed 2 key flashes after every
100 hours of operation. You must replace
your carbon filter. Consult an authorized ser-
vice for this. After replacement, the lamp
warning of Speed 2 key does not turn off
automatically. When you touch the speed 2
button for more than 3 seconds, carbon filter
fill warning is reset and the lamp is turned
off.
If the power is cut when the hood
gives carbon filter fill warning, then
the warning is not cancelled. When
power is available, it continues to
warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning flashes again.
EN / 15
Advertisement
Table of Contents
