Siruba F007KD Parameter Manual page 9

（3）裝電機：Install Moter
a)如安裝圖所示將圖⑨電機裝入並用圖⑩螺釘鎖緊固定在圖①底板上
（注：電機裝入轉子要注意磁鐵吸力，小心夾到手。）
According to the above install picture,use the screw(picture⑩)to fix the
motor(picture⑨) in to the plate(picture①).(attention: please take care the
magnetism to hurt the hand when put the motor to the rotor.)
（4）檢查轉子和定子是否裝好
Check the rotor and the stator is installed or not
A）拿出圖⑨上的橡膠孔塞。
Taking out rubber hole stopper. (of picture⑨ )
B）目測轉子平面與定子平面是否相平，兩面相平度不得超過 1.5mm
（看剖視圖 A),如果超過 1.5mm 的話,要拆掉電機和轉子用圖⑤墊片來調
整。
Check the plane of the rotor and the stator is flat or not, two surface
roughness shall not exceed 1.5mm(See section view A), if more than 1.5mm,
to remove the motor and the rotor with figure⑤gasket to adjust
.
C）調整好後裝回橡膠孔塞。（注：電機兩平面裝的越平越好，如果
兩平面超過 1.5mm 的情況下，電機會比正常安裝的發熱量大和力矩減
小現象。）
圖 A