Table of Contents
Advertisement
8-5. Tire maintenance
Related Links
Setting the tire pressure(P. 537)
Canceling ID code registration
To cancel ID code registration after it has been started, select [New tire registra-
tion] again on the center display.
If ID code registration has been canceled, the tire pressure warning light will turn off.
If the warning light does not turn off, ID code registration may not have been cancelled
correctly. To cancel registration, select [New tire registration] again on the center display.
Selecting wheel set
Your vehicle is equipped with a tire pressure warning system with a function to
register two sets of ID codes. This allows for registration of a second wheel set, for
example a winter set.
The wheel set can be changed only if a second wheel set has been registered to
●
the system. If a second wheel set has not been registered, "Set 2(Unregistered)"
will be displayed and it will not be possible to change to the selected wheel set.
ID codes can be registered by yourself.
Only a change between both registered wheel set is possible, mixing between
●
these wheel sets is not supported.
While registering ID codes, it may not be possible to change between wheel
●
sets normally. Cancel registration before changing between wheel sets.
1
Install the desired wheel set.
2
Select
on the center display.
3
Select [Vehicle customize].
4
Select [Tire pressure].
5
Select the wheel set ([Set 1] or [Set 2]) displayed for the set selection setting.
6
Select the wheel set you wish to register, and then select [OK].
The tire pressure warning light will slowly blink 3 times, a message indicating that
change is occurring will be displayed, and the wheel set change will begin.
Wheel set change will begin and the tire pressure warning light will blink for 1 minute
and then illuminate. Also, while the change is being performed, "---" will be displayed
for the tire inflation pressure of each tire on the multi-information display.
542
Advertisement
Table of Contents
