UfiSpace S9300-32D Hardware Installation Manual page 26

400ge spine switch
Table of Contents

Advertisement

2.6
Use a heat source to secure the heat shrink tubing in place. Allow the heat shrink tubing
to cool before attaching the DC power cable. An example of the installed DC version with
insulation material as below.
3. Attach the power cable.
Locate the DC power screw-type terminal block located on the PSU. Remove the plastic cover
that is protecting the terminal block by pushing from the top or bottom of the cover and
flipping open the cover outwards (Top picture). Secure the one-hole lug (with the DC power
cable attached) to the terminal block (Middle picture). Put plastic cover back on terminal block
to guard against contact with terminals (Bottom picture).
Figure 31.
Figure 32.
S9300-32D Hardware Installation Guide | 23

Advertisement

Table of Contents
loading

Table of Contents