Table of Contents
Advertisement
ACCESSORIES
•
Wire shelf
For cookware, cake tins, roasts.
•
Baking tray
For cakes and biscuits.
•
Turnspit
BEFORE FIRST USE
WARNING! Refer to Safety chapters.
INITIAL CLEANING
Remove all accessories from the appliance.
Refer to "Care and cleaning" chapter.
Clean the appliance and the accessories before
first use.
Put the accessories back to their initial position.
PREHEATING
Preheat the empty appliance to burn off the
remaining grease.
HOB - DAILY USE
WARNING! Refer to Safety chapters.
IGNITION OF THE HOB BURNER
Always light the burner before you put
on the cookware.
WARNING! Be very careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case of
the flame misuse.
1. Push and hold the spark generator button
2. At the same time turn the knob for the hob
counterclockwise to the maximum gas flow
position
and push it down to light the
burner.
3. Release the spark generator button when
burner lights but keep the knob on this position
for equal or less than 10 seconds to let the
thermocouple warm up. If not, the gas supply
will be interrupted.
For roasting larger joints of meat and poultry.
•
Grill deflector
To protect the knobs when you use the grill.
•
Storage drawer
The storage drawer is below the oven cavity.
1. Set the maximum temperature.
2. Let the appliance operate for approximately 1
hour.
WARNING! Accessories can become
hotter than usual.
The appliance can emit an odour and smoke. This is
normal. Make sure that the airflow is sufficient.
Let the oven cool down. Dampen a soft cloth with
warm water and a little mild washing-up liquid and
use this to clean the oven cavity.
4. Adjust the flame after it is regular.
WARNING! Do not keep the knob
pushed for more than 15 seconds. If
the burner does not light after 15
seconds, release the knob, turn it into
the off position and try to light the
burner again after minimum 1 minute.
If after some tries the burner does not
light, check if the crown and its cap
are in the correct position.
In the absence of electricity you can
ignite the burner without an electrical
device. In this case approach the
.
burner with a flame, push the relevant
knob down and turn it to maximum
position. Keep the knob pushed for
equal or less than 10 seconds to let
the thermocouple warm up.
13
Advertisement
Table of Contents
