Iceco VL35 Manual
Hide thumbs Also See for VL35:

Advertisement

Quick Links

VL35 / VL42 / VL45 / VL52

Advertisement

Table of Contents
loading

Summary of Contents for Iceco VL35

  • Page 1 VL35 / VL42 / VL45 / VL52...
  • Page 2: Table Of Contents

    CONTENTS 1 SAFETY INFORMATION 1.1 Warning 1.2 Notice 1.3 Inended to Use 1.4 Correct Disposal of This Product 1.5 Danger 2 MEASUREMENTS 3 CONTROL PANEL 3.1 Using The Control Panel 3.2 Opreating 3.3 Display 4 IMPORTANT INFORMATION 5 FITTING THE EXTENSION COLLAR AND HIGH LID 6 INSTALLATION AND OPERATION 6.1 12V Installation 6.2 240V Installation...
  • Page 3: Safety Information

    NOTICE ● No responsible for the damage by ignoring the safety instructions ICECO. ● The use of accessories that are not recommended by ICECO can cause injuries and will invalidate any warranty that you may have. ● Place the products so that they do not collide against each other or break when the appliance is in motion.
  • Page 4: Measurements

    4. When your ICECO is running it will operate at 2˚C either side of set temperature. For example, with your ICECO set at 0˚C it will run until reaches –2˚C and then stop. The green energy saving light illuminates when the compressor is cycled off.
  • Page 5: Display

    Turn off the S1 switch, the LCD screen and LED indicators stop working. IMPORTANT INFORMATION Do not lay your ICECO on its back or sides or at any angle exceeding 40º. • Never operate your ICECO directly from 240V mains power without using a 240V – 12V adapter.
  • Page 6: Installation And Operation

    Equalising fridge temperature If you run your ICECO using the 240V adapter for 4 or 5 hours before placing in your vehicle, this will ensure that the internal air temperature, condensor and insulation has had time to equalise. Doing this will result in shorter cycle times and more efficient operation once you run your ICECO on 12V.
  • Page 7: Cut In / Cut Out

    (less than 6mm direct to battery) or if there is a loose connection somewhere. ● If this occurs when you try and start your ICECO and the power supply drops under 10.9V it will not start. If this occurs when your ICECO is running and the power supply drops below 9.6V it will stop.
  • Page 8 ICECO product comes with a 5-year warranty on the compressor and 1 year warranty on all other parts for your peace of mind. In the unlikely event this product fails when used according to our user guide, we will either repair or replace it. For full warranty terms and conditions on this product, please see the user guide.

This manual is also suitable for:

Vl42Vl45Vl52

Table of Contents