Sony SLV-X9N ShowView Operating Instructions Manual page 19

5
Press PROGRAM +/– (repeatedly) to select the appropriate TV
PROGRAM
system for your area. Select "G" for the B/G TV system, or "K" for
the D/K TV system.
6
Tune the TV to the same channel
shown in the VCR display window
so that the picture on the right
appears clearly on the TV screen.
Refer to your TV manual for TV
tuning instructions.
If you select the wrong TV system in
step 5, the picture on the right may
not appear. Select the appropriate TV system and tune the TV
again.
If the picture does not appear clearly, see "To obtain a clear picture
from the VCR" below.
7
Press RF CHANNEL.
AUTO
SET UP
You have now tuned your TV to the VCR. Whenever you want to
play a tape, set the TV to the video channel.
RF CHANNEL
To check to see if the TV tuning is correct
Set the TV to the video channel and press PROGRAM +/– on the VCR. If
the TV screen changes to a different programme each time you press
PROGRAM +/–, the TV tuning is correct.
To obtain a clear picture from the VCR
If the screen does not appear clearly in step 6 above, go to step 7 to finish this
procedure once. Then start again from step 2. After pressing RF
CHANNEL in step 2, press PROGRAM +/– while the RF channel is
displayed, so that another RF channel appears. Then tune the TV to the new
RF channel so that a clear picture appears.
Note
• If you set the wrong TV system, you may have no sound or sound may be distorted.
SONY VIDEO CASSETTE RECORDER
continued
Tuning your TV to the VCR
19