Step 2 : Setting Up The Remote Commander - Sony SLV-X9N ShowView Operating Instructions Manual

Step 2 : Setting up the remote commander

Inserting the batteries
Insert two R6 (size AA) batteries
by matching the + and – on the
batteries to the diagram inside the
battery compartment.
Insert the negative (–) end first,
then push in and down until the
positive (+) end clicks into
position.
Using the remote
commander
You can use this remote
commander to operate this VCR
and a Sony TV. Buttons on the
remote commander marked with a
dot (•) can be used to operate your
Sony TV. If the TV does not have
the
sensor, this remote commander
will not operate the TV.
To operate
the VCR
a Sony TV
10
Setting up the remote commander
symbol near the remote
Set [TV] / [VIDEO] to
[VIDEO] and point at the remote sensor at the VCR
[TV] and point at the remote sensor at the TV
Remote sensor
1 2 3
4 5 6
7 8 9
0
[TV] /
[VIDEO]