Electrical Connection - IKEA MATMASSIG Manual

ENGLISH
General information
590 mm
490 ±1
mm
min.
55 mm
max.
R 5 mm
min.
28 mm
Installation process must follow
the laws, ordinances, directives
and standards (electrical safety
rules and regulations, proper
recycling in accordance with the
regulations, etc.) in force in the
country of use!
• For further information on the installation
refer to the Assembly Instruction.

Electrical connection

Warning! Refer to Safety
chapters.
Warning! All electrical
connections must be made by an
authorised installer.
Electrical connection
• Before connecting, check if the nominal
voltage of the appliance, provided on the
rating plate, corresponds to the available
supply voltage. The rating plate is located
on the lower casing of the hob.
min.
520 mm
500 mm
560 ±1
mm
min. 50 mm
• If there is no oven beneath the hob,
install a separation panel under the
appliance according to the Assembly
Instruction.
• Do not use silicon sealant between the
appliance and the worktop.
• Follow the connection diagram (it is
located on the underneath surface of the
casing of the hob).
• Use only original spare parts provided by
spare parts service.
Connection cable
• The appliance is supplied with the
connection cable.
• Replace the damaged mains cable only
with the spare parts cable. Contact your
IKEA store call centre.
Caution! Do not solder any wires!
One-phase connection
30
min.
28 mm
min.
5 mm