Warning; Precautions - Sony RDR-HX910 Operating Instructions Manual

WARNING

To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to qualified
personnel only.
The power cord (mains lead) must only
be changed at a qualified service shop.
This appliance is classified as a
CLASS 1 LASER product. The
CLASS 1 LASER PRODUCT
MARKING is located on the laser
protective housing inside the
enclosure.
CAUTION
The use of optical instruments with this
product will increase eye hazard. As
the laser beam used in this DVD
recorder is harmful to eyes, do not
attempt to disassemble the cabinet.
Refer servicing to qualified personnel
only.
This label is located on the laser
protective housing inside the
enclosure.
Изготовитель:
Сoни Кopпopейшн
Адрес:
6-7-35 Киташинагава,
Шинагава-ку, Токио
141-0001, Япония
Страна-производитель:
Малайзия
2

Precautions

• This unit operates on 220 – 240 V
AC, 50/60 Hz. Check that the unit's
operating voltage is identical with
your local power supply.
• To prevent fire or shock hazard, do
not place objects filled with liquids,
such as vases, on the apparatus.
S V is a registered trademark of
HOW IEW
Gemstar Development Corporation.
The S V system is
HOW IEW
manufactured under license from
Gemstar Development Corporation.
Disposal of Old Electrical &
Electronic Equipment
This symbol is applicable only in the
European Union and other European
countries with seperate collection
systems.
Precautions
This equipment has been tested and
found to comply with the limits set
out in the EMC Directive using a
connection cable shorter than
3 metres.
On safety
Should any solid object or liquid fall
into the cabinet, unplug the recorder
and have it checked by qualified
personnel before operating it any
further.
About the hard disk drive
The hard disk has a high storage
density, which enables long
recording durations and quick
access to the written data. However,
it can easily be damaged by shock,
vibration or dust, and should be kept
away from magnets. To avoid losing
important data, observe the
following precautions.
• Do not apply a strong shock to the
recorder.
• Do not place the recorder in a
location subject to mechanical
vibrations or in an unstable
location.
• Do not place the recorder on top of
a hot surface, such as a VCR or
amplifier (receiver).
• Do not use the recorder in a place
subject to extreme changes in
temperature (temperature gradient
less than 10 °C/hour).
• Do not move the recorder with its
power cord (mains lead)
connected.
• Do not disconnect the power cord
(mains lead) while the power is on.
• When disconnecting the power
cord (mains lead), turn off the
power and make sure that the hard
disk drive is not operating (the
clock is displayed in the front
panel display and all recording or
dubbing has stopped).
• Do not move the recorder for one
minute after you have unplugged
the power cord (mains lead).
• Do not attempt to replace or
upgrade the hard disk by yourself,
as this may result in malfunction.