Step 4: Connecting The Audio Cords - Sony RDR-HX910 Operating Instructions Manual

Step 4: Connecting the Audio Cords

Select one of the following patterns A or B, according to the input jack on your TV monitor, projector,
or AV amplifier (receiver). This will enable you to listen to sound.
A Connecting to audio L/R input jacks
This connection will use your TV's or stereo amplifier's (receiver's) two speakers for sound. You can
enjoy the following surround effects (page 51).
• TV: Dynamic, Wide, Night
• Stereo amplifier (receiver): Standard, Night
B Connecting to a digital audio input jack
If your AV amplifier (receiver) has a Dolby
jack, use this connection. You can enjoy Dolby Digital (5.1ch), DTS (5.1ch), and MPEG audio (5.1ch)
surround effects.
Optical digital cord (not supplied)
[Speakers]
Rear (L)
Front (L)
Centre
: Signal flow
* The yellow plug is used for video signals (page 14).
16
(red)
(white)
(yellow)*
LINE OUT
R-AUDIO-L VIDEO S VIDEO
AERIAL
DIGITAL
OUT
IN
LINE IN
PCM/DTS/MPEG
DOLBY DIGITAL
R-AUDIO-L VIDEO
COAXIAL
OUT
OPTICAL
DIGITAL
OUT
to DIGITAL OUT (COAXIAL or OPTICAL)
PCM/DTS/MPEG/
DOLBY DIGITAL
COAXIAL
OPTICAL
to optical
digital input
AV amplifier (receiver)
with a decoder
*1 *2
Digital, DTS , or MPEG audio decoder and a digital input
Audio/video
cord (supplied)
to LINE OUT (R-AUDIO-L)
COMPONENT
VIDEO OUT
Y
S VIDEO
LINE OUT
1 R-AUDIO-L VIDEO S VIDEO
P /C
B B
3
P /C
R R
or
Coaxial digital cord (not supplied)
to coaxial
digital input
INPUT
(yellow)
VIDEO
(white)
L
AUDIO
(red)
R
TV, projector, or AV
amplifier (receiver)
~
AC IN
[Speakers]
Rear (R)
Front (R)
Subwoofer
A
DVD recorder
B