Warning - Sony RDR-VX500 Operating Instructions Manual

WARNING
To prevent fire or shock hazard,
do not expose the unit to rain or
moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing
to qualified personnel only.
The AC power cord must be
changed only at a qualified
service shop only.
I I_t'_F_
CLASS 1 LASER PRODUCT
LASER KLASSE 1
LUOKAN 1 LASERLAUTE
KLASS 1 LASERAPPARAT
This appliance is classified as a
CLASS 1 LASER product. The
CLASS 1 LASER PRODUCT
MARKING is located on the rear
exterior.
CAUTION
The use of optical instnnnents witb tbis
product will increase eye hazard. As
the laser beam used in this VCR-DVD
recorder is harmful to eyes. do not
attempt to disassemble tile cabinet.
Refer servicing to qualified personnel
only
This symbol is intended
to alert the user to the
presence of uninsulated
"dangerous voltage"
within the product's
enclosure tbat may be of sufficient
magnitude to constitute a risk of
electric shock to persons
This symbol is intended
to alert tbe user to the
presence of impollant
operating and
maintenance (sel-vicing)
instructions in tbe literature
accompanying file appliance
CAUTION
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG
TO WIDE SLOT. FULLY INSERT
CAUTION
You are cautioned that any change oi
modifications not expressly approved
in this manual could void your
authorib, to operate tiffs equipment
This eqmpment has been tested and
found to comply with tile limits for a
Class B digital device, pursuant to Part
15 of the F(( Rules These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
con1111/lnlcations However. there is no
guarantee that interference will not
occur in a particular installation If this
equipment does cause harmfifl
interference to radio or television
reception, which can be deterlmned by
turning the equipment off and on, the
user
is
encouraged to
tl),
to correct
the
interference by one or more of the
following measures:
Reorient or relocate tbe receiving
antenna.
Increase the separation between the
eqmplnent and receiver.
Connect the equlplnent into an outlet
on a circuit different froln tbat to
which the receiver is connected.
Consult the dealer or an experienced
radioiTV technician for help
V(R Plus+ and PlusCode are
registered trademarks of Gelnstar
Development Co_poration The V(R
Plus+ system is manufactured under
license from Gelnstar Development
Corporatmn