Reversible Door Exchange - IDW G Series Instruction Manual

Instruction Manual
DOOR REVERSAL (For G-7f Coolers Only)
1 Remove the plastic cover on the bottom hinge, disconnect the
reversible d oor e xchange
terminals and then hide the terminals in the door's reserved hole.
1.disassemble t he t he h inge l atch o f l eft h and d oor.
2. d isassemble t he f ront g rill, d isconnect t he t erminals,
then h ide t he t erminals i nto d oor's r eserved h ole.
2 Remove the right upper hinge, then remove the door.
3.disassemble t he r ight u pper h inge, t hen r emove t he
door.
3 Take out the torsion rod from the upper right of the
4 Pull out the wiring from door's reserved hole, the
5 Insert the torsion rod into corresponding holes on
4.draw o ut t he s tructure o f s elf-­‐closing d oor,then
assemble t he s tructure i nto d oor o ther s ide .
6 Rotate the door clockwise 180°, so the wiring is
5.clockwise r otate t he d oor 1 80°.
7 Remove the hinge axis from the right bottom hinge,
6.draw o ut t he h inge a xis f rom r ight b ottom h inge, i nsert
it i nto l eft b ottom h inge.
7.The t erminals o f d oor L ED l ights w iring i s t aken o ut f rom
door.
wiring stretches out from the upper right of door.
bottom right of the door.
stretched out from the bottom left of the door.
insert it into the left bottom hinge.
DOOR REVERSAL Cont. (For G-7f Coolers Only)
11
12
G-7f/GCG-7f
8 Feed the wiring terminals through the hinge and connect
the terminals.
9 Reinstall the torsion rod into the new
position of the door axis.
10 Set the upper hinge into the torsion rod at approximately
a 60°angle. Rotate the hinge to the right counter-
clockwise aligning the holes in the bracket with the holes
on top of the cabinet.
11 Install the limiter on the door. Installing sequence—
the washer—gasket-limit-bolt.
12 Check to ensure the door is securely attached and
functioning properly.
Innovative DisplayWorks