Troubleshooting - SECO-LARM E-941S-600DPSQ Series Installation Manual

SECO-LARM Electromagnetic Locks

Troubleshooting

Doors lock, but can easily
be forced open
Delay in door releasing
IMPORTANT WARNING: Incorrect mounting which leads to exposure to rain or moisture inside the enclosure could cause
a dangerous electric shock, damage the device, and void the warranty. Users and installers are responsible for ensuring that
this product is properly installed and sealed.
IMPORTANT: Users and installers of this product are responsible for ensuring that the installation and configuration of this
product complies with all national, state, and local laws and codes. SECO-LARM will not be held responsible for the use of
this product in violation of any current laws or codes.
California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to
cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
LIMITED LIFETIME WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship
while used in normal service for the lifetime of the product. SECO-LARM's obligation is limited to the repair or replacement
of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused
by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration, improper or abnormal
usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly
as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM and the purchaser's
exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM's option. In no event shall SECO-LARM
be liable for any special, collateral, incidental, or consequential personal or property damage of any kind to the purchaser or
anyone else. For all other countries, the warranty is 1 (one) year.
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves
the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks are the
property off SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2021 SECO-LARM U.S.A., Inc. All rights
reserved.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800 Email: sales@seco-larm.com

Make sure the electromagnet and armature plates are properly
aligned.

Make sure the contact surfaces of the electromagnet and armature
plates are clean and free from rust.

Check the power leads with a meter, and make sure 12VDC or
24VDC is present.

Make sure the rubber washer is installed and free from damage.

The electromagnet is fitted with a metal oxide varistor to prevent
interference, so do not install a second diode.

Ensure that the control device is connected between the power
source and the positive terminal of the lock
®
U.S.A., Inc.
Website: www.seco-larm.com
PITGW1
MI_E-941Sx-xxxxxxQ_211025.docx