Electromagnetic gate lock with door cord (4 pages)
Summary of Contents for SECO-LARM ENFORCER SD-961A-36
Page 1
SD-961A-36 Push-to-Exit Bar Manual Features: For allowing egress from inside an area Two dual-contact switches (NO/COM/NC): normally locked by an electromagnetic lock, 25A@ 24VAC and/or to disarm or trigger an alarm when Length of bar: 34.5 inches (for standard the door is opened 36-inch wide door), can be cut to size ...
Page 2
Remove the end cap nearest the wire connector from the base unit. Cut both the base unit and the aluminum top by the same amount. Replace the end cap. Double-check the length by holding the push bar and aluminum top against the door. SECO-LARM U.S.A., Inc.
Page 3
Switch 2 N.C. (release bar to send signal) N.C. (release bar to send signal) N.O. (push bar to send signal) N.O. (push bar to send signal) NOTE: For fail-safe electromagnetic locks, connect for push-to-open (N.C. & COM) SECO-LARM U.S.A., Inc.
Page 4
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if...