Advertisement
AXIS 2191 Installation Guide - DRAFT COPY
Configuring the Audio Module
The network camera's administration pages provide all the tools required for successfully configuring
the AXIS 2191. From the camera's home page, click on the Admin link. A new page containing the
administration tools will open.
Software version
shown in title bar
To complete the configuration of your audio module, follow these instructions:
1.
From the Admin tools, click External Devices. Select the AXIS 2191 Audio Module as the device
to use. Click Save.
2.
Under External Devices, click Audio. This opens the configuration page for the audio module.
3.
Select the audio mode. This can be:
• Full Duplex (Talk and Listen Simultaneously)
• Half Duplex (Talk and Listen)
• Simplex - Talk
• Simplex - Listen
This selection will depend on your application. See pages 1 and 5 for more information.
4.
Enter the number of clients that will be able to access the application at any one time. Use this
setting to limit access if you have only limited bandwidth available.
5.
If you are using Half Duplex mode, select whether or not to Send Audio to other clients on
receive. This can be used to allow the audio signal from one client to be sent to all other clients,
and not just to the server end.
6.
When using Half Duplex, the Push-To-Talk button will be visible. Select the mode to use for this
button. Selecting Toggle means that when the button is pushed it will remain so until pushed a
second time. Instant means that the button will remain pushed for as long as the user holds it
pushed, i.e. until the mouse button is released.
7.
Adjust the Volume In control so that the LED occasionally shows yellow, but not red.
8.
Adjust the Volume Out control until a satisfactory level is heard. The Level Out LED can be used
to check that there is audio being received by the Audio Module.
Admin
On-line
tools
Help
Page 4 of 7
Admin
link
Advertisement
