Advertisement
AXIS 2191 Installation Guide - DRAFT COPY
Installing the Audio Module
Follow the guide below to quickly get your AXIS 2191 up and running. Refer to the illustrations on
the previous page for connector details.
❶ Firstly, your network camera must have the correct software version installed. This can be checked
by opening the camera's home page in your browser and checking the version number displayed in
the browser's title bar. Please refer to the CD supplied with your AXIS 2191 for instructions on
updating the software. If you purchased your AXIS 2191 as part of a package, together with a
network camera, then the correct software should already be installed in the camera.
❷
If using an external microphone, connect it to
the socket provided. To use an alternative input
device, (e.g. CD-players or radios) connect it to
Line-In on the terminal block.
❸
Set the selector switch
to Ext to use an external
microphone or device.
Otherwise set to Int to use
the internal microphone.
❺
Connect power to the audio module.
❼
Check that the power indicators on both the audio module and the
camera are lit. Note that the power LED will blink during power-up.
Note:
If you are in doubt about which software version is required, or if you wish to download the latest
version, please see the AXIS 2191 product pages at www.axis.com. Full instructions on how to
update the camera software are provided with each software release.
❹
only), or to Out on the terminal block (speakers with no amplifica-
tion). Other devices (including headphones) are connected to the
terminal block.
❽
Verify the connection to the AXIS 2191 by starting your browser and entering the IP address
of the network camera in the location/address field, e.g. 171.21.1.200. Configure the audio module
from the camera's administration pages, as described below.
Connect a loudspeaker to the 3.5mm socket (amplified speakers
❻
Using the supplied cable, connect the audio module's
serial port to the network camera's serial port.
Page 3 of 7
Advertisement
